All Questions
Tagged with status-completed discussion
10 questions
3
votes
2
answers
206
views
Please vote: Do we want an AI warning banner?
This could be considered to be a follow-up of AI generated content is problematic
Can I draw your attention to this post on SE.Meta, Sites can now request to enable a banner to warn about their ...
GreenonlineMod
- 6,688
10
votes
0
answers
186
views
We're graduating!
3DPrinting Stack Exchange is leaving Beta in mid-December.
What is Beta?
As the (somewhat out of date) Help Center article says:
“Beta” means that the site is still being defined and constructed.
We ...
0scarMod
- 37.1k
6
votes
3
answers
306
views
Does this 3D Printing site want only three votes to close (or should we stick with five)?
I've just noticed this Meta post, Testing three-vote close and reopen on 13 network sites and I wondered whether we should employ it here, and what do other people think?
We are a smallish site, with ...
GreenonlineMod
- 6,688
3
votes
3
answers
209
views
Which character to use to activate MathJax?
We were offered to get MathJax enabled.
Now, we need to decide on which character to have text between them parsed into MathJax! So please either add your suggestion or cast your vote!
- 22.5k
8
votes
2
answers
253
views
Can we get MathJax enabled?
Our site is dealing with electronics and practical engineering, so we use formulas in questions and answers on occasion, most usually when we have to figure out electronic ratings.
When we talk ...
0scarMod
- 37.1k
3
votes
1
answer
46
views
Tag required for "object removal from print bed"
With respect to this question, How can you both reliably print and remove your item without breaking it when detatching it?, the OP rightly states the following:
ps. I didn't find (and I can't make ...
GreenonlineMod
- 6,688
8
votes
4
answers
338
views
What does it take to get out of Beta stage?
I can't find an answer to this question on the "mother" meta website; hope this is not related to my choice of words in the search box.
The statistics of the 3D Printing on Area51 show that only few ...
0scarMod
- 37.1k
4
votes
2
answers
73
views
Should we turn on "inlined video"? [duplicate]
We have, now, assertained that inlined videos (for want of a better description) are currently turned off (disabled) for SE 3D Printing, but can be turned on at any time, and there is no need to wait ...
GreenonlineMod
- 6,688
2
votes
3
answers
114
views
Is the "inlining videos" capability turned off on this site? [duplicate]
I have just edited a new post, Help understanding bridge settings, so that the video would be "inlined" and playable in the post itself1.
However, the video does not show up, and only the ...
GreenonlineMod
- 6,688
1
vote
1
answer
261
views
Do we want MathJax support on 3D Printing? [duplicate]
MathJax support allows questions and answers to contain pretty mathematical formulae, easy subscripts & superscripts, fractions, roots and greek letters etc. all using LaTeX syntax.
I have seen ...
- 335